The Newman's Energy Machine

By JL Naudin/M.David

created on 06/12/98 - JLN Labs - last update on 06/22/98

06-22-98 - Additional comments from JL Naudin

In the two diagrams above you can see :

The first diagram shows three curves :

1-a) The BLUE curve (the input current) is the real current flow INPUT measured accross a 100 ohms resistor connected in series with the coil. This current input is measured while the rotor is rotating in the coil.

1-b) The RED curve (the "inductor charging" current) is the current needed for FILLING the COIL with magnetic energy while the voltage is maintained constant. The magnetic energy in the coil is Wm=0.5*L² after 5*Tau = 5*L/R about 68 ms. This is the Magnetic energy charging current when the rotor does not rotate in the coil.

1-c) The GREEN curve (the "magnetomotive" current) is the current GENERATED by the rotation of the magnet through the coil. You may notice that the shape of the curve has the SAME shape than the voltage generated in the coil shown in the "free run" diagram. This confirms the fact that this current is the real "magnetomotive" current.

Link to the Efficiency testing - Test RUN 1

If you need more informations or if you have any suggestions send me your Feedback

Email : [email protected]

Return to the Newman's Machine Main page